do it yourself diy baby blocks for shower

#DO IT YOURSELF DIY BABY BLOCKS FOR SHOWER HOW TO#
#DO IT YOURSELF DIY BABY BLOCKS FOR SHOWER INSTALL#

It is necessary for the prevention of water leaking. Lay of shower pan materialįirst, you should purchase shower pan materials or tarp in a construction store. Now, you need to let the material dry off at least 24 hours. If you use an adjustable drain, there is no need to pay attention to that detail. It is an excellent idea to place the shower drain a bit over the level because you need to lay the ceramic tiles around it later on. When you evenly distribute the dry pan mixture, the next step is to make sure that the surface is leveled appropriately. Therefore, the parts closer to the wall should be approximately 0.25 inches (6 mm) higher than the area around the drain. Always keep in mind that water should flow towards the drain. Once you are ready to fill the area around the drain, you should begin the job from the walls to the drain. An excellent dry pan mixture should be dry enough, but easy to sculpt at the same time. You should add water while mixing them, but avoid putting in too much of it. My winning recipe is a mix of one part cement and four parts sand.

#DO IT YOURSELF DIY BABY BLOCKS FOR SHOWER HOW TO#

If you decide to use mortar, you should read the instructions on the package on how to make it. Make a dry pan mixture by combining sand and cement with a suitable amount of water. After inserting and fixating the beams, you need to make sure they are leveled.

You can buy the beams, which are already cut to a suitable length, or you can cut them by yourself with a circular saw.

#DO IT YOURSELF DIY BABY BLOCKS FOR SHOWER INSTALL#

Option two (beam step) – If you are not skillful enough with construction work, I advise you to install a beam step.

The best option is to place the shower step between the horizontal studs in the future wall. That will be the only side without a wall. Insert them at the entrance of your shower.

Option one (shower step) – You can use the beams to make a shower step of a suitable size.

It’s up to you if you want to leave your shower cabin open or to install a shower door in the end. Now, you should make a shower step or a beam step, depending on the option you have chosen. Install the bottom drain flange and stick the duct tape over it to protect the drain from dirt. That will help you a lot if you need to put it higher or lower from the pan level. My advice is to purchase the one that is easy to use and has an adjustable height. Install drainer and shower step/beamĪfter deciding which type of drain for a shower you want to use, you should start paying attention to the details. After drying the floor, you can start with real work. Then prepare the entire area for smooth operation by clearing all debris from the surface. Start with measuring the place where you want to install your new shower pan. Either way, the procedure is the same in the very beginning. Then, think about different options, such as a walk-in shower or a curb. Which material you need depends on the type of shower floor you want to build.įirst of all, you should decide if you want to buy a shower pan or you prefer making it by yourself. In the very beginning, you should be aware that you need adequate tools and materials along with primary building and ceramic skills to finish the job.

Do it yourself diy baby blocks for shower